Faqs

Location:  Home > Contact > Faqs


Faqs

Faqs

Shake head light bulb does not work, how to do?

1. Turn on the tail of the lamp body to check whether the bulb turns white or black. If the above two phenomena appear, please replace the bulb first and try again.

2. Open the two shells of the lamp body, install the trigger on the lamp post, check whether the trigger wiring is black, and replace the trigger if any.


How to do if the bulb of shake head lamp blows up?

1: First, check whether the voltage is between 220 V and 230 v. if the voltage exceeds 230 V, it is possible to explode bubbles (so it is suggested that voltage regulators should be installed in various places);

2: In case of bubble explosion, please check whether the bubble is caused by long service life (generally, the normal service life of domestic bulb is within 300-500 hours);

3: Is there a problem with the quality of the bulb?

4: If none of the above three methods is correct, there may be a problem with the ballast.


When shaking the head lamp, it sounds like something is stuck. What should I do?

Take apart the shell by ourselves to see if the lamp is deformed. If it is deformed, we will see if the lamp is straightened. If it is not deformed,

Check the circuit and motor from the main board to the XY axis motor,

It's hard for us to turn the normal motor by hand after the lamp is powered on, but it's easy for us to turn the bad motor by hand.

If there is no problem with the motor and circuit, just check whether the reading disk and optocoupler are broken,

After the reading disk and optocoupler are replaced, if the problem is not solved, replace the motherboard.


How to do when the bulb of shake head lamp is on or off?

1. Check whether the bulb is white, black or swollen. Please replace the bulb in case of the above conditions to avoid damage to the product.

2. Check whether the fans on both sides of the bulb are working normally. If there are any broken fans, please replace them in time;

3: Please open the two shells, and there is a white temperature control in the layer of pattern chip and color chip to see if it is burnt out (if it is broken, it will not destroy the bubble);

4: Open the two shells of the lamp body, and there is a heat dissipation window on the tail of the bulb. After a long time, the wind path will be blocked,

If the cooling window is covered with dust, please clean it (the cooling window should be cleaned once a month for the best effect)


Shake head lamp is not electrified as a whole, how to do?

1. Check the power cord first.

2. Check whether the fuse of the power base is burnt out.

3. Turn on the base panel of the lamp and check whether the ballast is powered on and whether the internal switch connecting wire falls off.

4. Open the two shells of the lamp body, and check whether the temperature control fails near the bulb.